AEA RPQ500 500 series mic preamp/eq Original Cosmetics Version USED ITEM
SAVE BIG ON THIS USED AEA RPQ500! ORIGINAL VERSION COSMETICS with ROUNDED KNOBS - Looks basically new
The AEA RPQ500 preamp and EQ provides high-quality, high-gain, low-noise preamplification with a rich and musical sound that complements the natural tonality of your microphones. Fill up your 500-series lunchbox with these!
- Two channels with 81dB of sweet and quiet JFET gain
- High-frequency CurveShaper EQ and low frequency proximity control
- Mic and line inputs for mixdown EQ versatility
- Switchable phantom power, polarity, line/mic, and EQ inserts
- NoLoad™ 10k Ohm high-impedance circuitry providing better overall transients, frequency response, and higher output sensitivity
- Made in the U.S.A.
The AEA RPQ500 Ribbon Preamp and EQ provide two channels of high-output, high-impedance, and low-noise gain with a clear natural sound that brings out the full potential of your microphones.
Specifically designed for ribbon microphones, the RPQ500 excels at drawing out the warmth and lush sound that ribbons are uniquely known for.
The RPQ500 is a powerhouse that provides unparalleled high gain with low-noise. With 81db of JFET output, the RPQ500 gives you enough juice to record soft sources without ever having to worry about noise.
With the RPQ500, you will never consider a source too quiet to record with a ribbon mic ever again. Passive ribbons with low output levels require preamps that supply a high level of output. If the preamp you use doesn’t have enough clean gain, the mic signal may seem too soft or noisy which may be apparent when recording quiet acoustic guitars or strings, especially at a distance or with long cable runs. The RPQ500 eliminates this concern.
The RPQ500’s CurveShaper™ EQ is a powerful tool that gives you the ability to control your ribbons right at the start of the signal path. Adjustable low and high-frequency controls allow you to tame proximity problems and provide high-frequency extension with slope control.
The high-frequency filter boost enables you to add presence and air to your source –perfect for sources like ribbons and 2-busses that often benefit from some extra top-end. The low-frequency control easily removes bass build-up in a fast and unobtrusive way.
HIGH IMPEDANCE MAKES A HUGE DIFFERENCE
The sound and tonality of dynamic ribbon and moving-coil microphones are directly affected by the impedance of a preamp. The higher the impedance, the better the sound. The RPQ500 boasts an extra high input impedance of 10K Ohms.
Preamps with an impedance of under 10k ohms will limit the lows, highs, and transients of your passive microphones. The RPQ500’s high impedance will reveal your microphone’s true nature– a thick low-end, open top-end, and articulate transient response that you will need to hear to believe.
Both condensers and active microphones will also benefit from the RPQ500’s impedance.
The Line/Mic switch bypasses the microphone gain stage and allows the EQ to be used for tracking with other preamps or during mixdown.
Add the output level control, and the RPQ500 becomes a high-quality processing tool that can be used for mixing and mastering when combined with a summing mixer such as the Phoenix Audio Nicerizer.